I'm not sure what I did wrong so many time before but this time the printer did some internal movements for about 15 seconds then everything went blank apart from the power button and then the PC pinged a message to say it was connecting a new device. Release the resume/cancel and press it 5 times. Press ON button while holding resume/cancel button (now you are holding both). ![]() ![]() Press and hold resume/cancel button (one with triangle in the circle). It was a little more tricky with the MG6250 as it doesn't actually have a mechanical button but a finger sensitive one similar to a smart phone so with the power off I had to guess where it was. Also I was trying when the printer was connected to a network and when changing to a direct USB connection, the buttons in the V3400 software were not greyed out. ![]() After a bit of trial and error I have managed to sort out the 006 error and successfully reset the 5B00 code on my MG6250.īasically I found that if the printer is not set properly in service mode then the 006 code appears on everything in the v3400 software.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |